Vogue Industrial ABOVE GROUND SWIMMING POOL Especificações

ROUND POOL ASSEMBLY INSTRUCTIONS Part# 420363-21 GENERAL Installation of this above ground pool is not extremely hard or confusing, but it is a

The spacing in all bottom plates should be equal. SKIMMER INLET SKIMMER OUTLET BOTTOM RAILS 2 PRE WASHED SAND OR SIFTED EARTH RECOMMENDED REQ

CLOSING THE WALL 4 Overtightening the nuts could cause the screws to fract

5 3 LAYERS OF TAPE CLOTH TAPE OR DUCT TAPE VIEW FROM INSIDE OF POOL WALL SEAM SKIMMER INLET FITTING SKIMMER RETURN FITTING 3 LAYERS OF

THRU-THE-WALL SKIMMER 8 IMPORTANT!! BEFORE CONTINUING WITH THIS STEP YOU MUST KNOW WHICH TYPE OF THROUGH THE WALL SKIMMER YOU WILL BE USING WIT

CAUTION YOUR POOL IS DESIGNED TO PROVIDE AN AMPLE SAFETY MARGIN WHEN IT STANDS ON LEVEL GROUND. FOR THIS PURPOSE A SLOPE I

EZ HOOK LINER INSTALLATION ATTENTION: An 8 inch cove must be placed all around the inside of the pool POOL WALL OUTSIDE VIEWO

1 VERTICALS 10 No. 12 x 1/2” Sheet Metal Screw If fencing or decking is to be installed, refer to the deck and fence instructions before installing

11 PRE-ASSEMBLY OF TOP PLATES* * NOTE: CAGE NUTS NOT NEEDED ON ALL POOLS - CHECK YOUR PACKING LIST Before the top plates are installed it is ne

INSTALLING LEDGES AND PLACEMENT OF WARNING LABELS 13 SCREW HOLE LOCATION GUIDE Refer to the "Const

INSTALLING TOP COVERS 14 FOLLOW THE INSTRUCTIONS BELOW FOR THE COVERS FOR YOUR PARTICULAR POOL 4", 6" & 7" DELUXE TOP COVERS Thes

SAFETY TIPS

6" & 7" TWO-PIECE FULL CONTOURED COVER Slide inside cover (the cover which will be closest to the inside of the pool) into position

7" AND 9” TWO-PIECE WRAP AROUND COVER AND PEDESTAL Slide the inside cover (the cover which will be closest to the inside of the pool) into

7" XL TWO-PIECE WRAP AROUND COVER AND PEDESTAL 1 - Insert the logo into the cover. 2 - Slide the outside cover in

WARNING WARNING LABELS 15 Four (4) danger labels have been provided for your safety. Apply these labels to the pool wher

PREVENTATIVE MAINTENANCE TIPS • Use clear lacquer or clear nail polish to cover screw heads. • Use clear lacquer or

HOW TO KEEP WATER CLEAR AND HEALTHFUL Your health, and maximum enjoyment is assured by keeping your pool water in sparkling c

SAFETY TIPS - RULES AND REGULATIONS • Never permit the pool to be used unless at least one person other than the b

CONTRACT INSTALLATIONS The manufacturer is in no way affiliated with any professional pool installer. Therefore the manufacturer

• During night time pool use, artificial lighting shall be used to illuminate all safety signs, ladders, steps, deck surfaces an

INSTALLATION • ASSEMBLY STEPS READ CAREFULLY BEFORE STARTING POOL ASSEMBLY CONSTRUCTION CLOSE-UPS Use the illustrations below as a guide for the as

INSTALLATION • ASSEMBLY STEPS READ CAREFULLY BEFORE STARTING POOL ASSEMBLY CONSTRUCTION CLOSE-UPS Use the illustrations below as a guide for the ass

INSTALLATION • ASSEMBLY STEPS READ CAREFULLY BEFORE STARTING POOL ASSEMBLY CONSTRUCTION CLOSE-UPS Use the illustrations below as a guide for the as

PREPARING THE GROUND 1 Your pool must be installed on a solid level surface. Drive a stake into the ground at the center